![]() Possibly most common is hot glue, low temp ideally. Ramming a clay plug, filling the salute, and then dealing with sealing the fuse end last is another good one. ![]() Ultimately tape can work instead of pasting, but pasting usually ends up cheaper, easier and more effective. This is held on, and the unit is sealed from lift gasses with two turns of paste soaked kraft paper, folding it down neatly over both ends. Traditionally one would cap such a salute with a fairly thick card disk, a few layers thick of serial box card can substitute in a pinch. ![]() The shells break itself also seems to be exceptionally strong and bright-perhaps from the flash powder in the salutes. ![]() Visco can work very well.īut if I use time fuse then there will be no room for plug in the salute, the time-fuse itself will act as the end-plug. I'm not using timefuse for the salutes, I'm using visco. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |